Royce Ayr Double O-Flute Router Bit 1/2 in (12.7 mm)
2-Flute Double O-Flute
Router Bit
Solid-carbide double O-flute router bit designed for clean CNC routing of soft plastic materials. Its 1/2-inch cutting diameter, 1-inch cutting edge, 1/2-inch shank, and 3-inch overall length support plastic-sheet profiling, component routing, trimming, and production machining where chip evacuation, edge quality, and heat control matter.
Main Product Description
The Royce Ayr 2-Flute Double O-Flute Router Bit for Soft Plastics R56-61414 is designed for clean routing of soft plastic sheet and components in CNC and router-based production environments. Its double O-flute geometry supports plastic machining where efficient chip evacuation, controlled heat generation, and clean edge quality are priorities.
The 0.5000-inch cutting diameter and 1.000-inch cutting edge provide a practical format for profiling, trimming, pocketing, and general soft-plastic routing. The matching 0.500-inch shank and 3.000-inch overall length provide a rigid interface for compatible 1/2-inch collets and toolholding systems.
This uncoated HW solid-carbide tool uses two cutting wings and right-hand rotation. Correct collet condition, minimum practical projection, verified runout, suitable RPM, feed rate, chip load, depth-per-pass, workholding, and chip evacuation are essential for controlling heat, maintaining edge quality, and supporting reliable tool life.
Best Fit Applications
Product Highlights
Double O-Flute Geometry
The two-wing O-flute form supports chip evacuation and clean edge quality when routing compatible soft plastics.
Heat-Controlled Plastic Routing
The geometry is intended for plastic machining where controlled heat generation and chip removal are important.
Rigid 1/2-Inch Format
The 1/2-inch cutting diameter and matching shank provide a stable configuration for compatible CNC router setups.
Compatibility & Installation Notes
Confirm that the spindle and toolholder accept an exact 1/2-inch (12.7 mm) shank and provide adequate clearance for the 3-inch overall length and required projection. Inspect and clean the collet, collet nut, and tool shank, minimize unsupported projection, verify runout, and confirm right-hand rotation before machining. Match RPM, feed rate, chip load, depth-per-pass, workholding, and chip evacuation to the selected soft-plastic material. This SKU is identified for soft plastics; do not extend its use to wood, aluminum, or composites without separate validation from the shop and tooling supplier.
Improve Soft-Plastic Routing Control
The Royce Ayr 2-Flute Double O-Flute Router Bit for Soft Plastics R56-61414 provides an uncoated HW solid-carbide solution for CNC and router-based production involving compatible soft plastic materials.
Its 1/2-inch diameter, 1-inch cutting edge, matching shank, two-wing O-flute geometry, right-hand rotation, and 3-inch overall length support controlled plastic machining when correctly held and operated.