Vortex Tool Series 1300XP Two-Flute Xtreme Performance Downcut Finishing Spiral Router Bit – 3/8 in Diameter x 7/8 in Cutting Length
Xtreme Performance
Downcut Finisher
A Vortex Tool Series 1300XP two-flute solid-carbide downcut finishing spiral with a 3/8-inch cutting diameter, 7/8-inch cutting-edge length, 3/8-inch shank, and 3-inch overall length. The downcut geometry is designed to support a clean top edge in compatible dado, groove, and through-cut applications.
Main Product Description
The Vortex Tool 1340XP is part of the Series 1300XP two-flute Xtreme Performance downcut finishing range. It is intended for difficult-to-cut compatible materials where tool life and top-edge finish are important production considerations.
Its downcut flute direction pushes cutting forces toward the workpiece surface, supporting a clean top edge in dado and groove operations and in through cuts where bottom-edge finish is not the primary requirement. The two-flute configuration provides a practical balance of cutting action and chip management when the tool is matched to the application.
The verified 1340XP configuration uses a 3/8-inch cutting-edge diameter, 7/8-inch cutting-edge length, 3/8-inch shank, and 3-inch overall length. Correct collet condition, spindle runout, tool projection, feed rate, RPM, cutting direction, and workholding remain essential to finish quality and tool life.
Best Fit Applications
Product Highlights
Xtreme Performance Geometry
The Series 1300XP geometry is designed for difficult-to-cut compatible materials where production tool life is a central concern.
Clean Top-Edge Focus
Downcut flute direction supports clean top-edge results in dado, groove, and selected through-cut operations.
Verified 3/8-Inch Format
The 3/8-inch cutting diameter and shank are paired with a 7/8-inch cutting length and 3-inch overall length.
Compatibility & Installation Notes
Confirm a clean, undamaged 3/8-inch collet or compatible holder, correct right-hand spindle rotation, adequate flute and shank engagement, safe tool projection, machine RPM limits, feed rate, cut depth, chip evacuation, workholding, and material support before use. Downcut geometry directs chips and cutting pressure toward the workpiece, so spoilboard condition, vacuum hold-down, and chip-clearance strategy must suit the operation.
Top-Edge Finishing Performance
Vortex Tool 1340XP combines a two-flute downcut finishing geometry with a verified 3/8-inch cutting diameter, 7/8-inch cutting length, 3/8-inch shank, and 3-inch overall length for compatible routing operations where clean top-edge quality matters.
Correct spindle condition, collet fit, tool projection, feed, RPM, toolpath, chip evacuation, and workholding are essential to achieving the intended finish and service life.